info@backesljud.se

  •  Fri frakt vid köp över 2000 kr
  •  Leveranser med DHL
  •  Trygg betalning med Klarna
0
Din varukorg är tom!

Helix DSP Mini

2 990 kr
Finns i lager för omgående leverans
Finns ej i lagret
Endast få kvar i lagret (1 st)
Finns ej i lagret
Bevaka produkt

Ange din e-postadress nedan så meddelar vi dig när produkten finns i lager! Din e-postadress sparas i upp till 180 dagar.

Produktbeskrivning:

Helix DSP MINI

Helix DSP Mini har en kraftfull prestanda med en Audio DSP men 64 bit upplösning.

Utrustad med ACO - Avances 32 Bit CoProcessor och har plats för 10 st presets.

Helix DSP Mini har plats för Helix Expansion Card (HEC) som ger dig möjligheten att uppgardera den med fler funktioner och ingångar/utgångar/bluetooth.

Smart högnivåingång med senatse ADEP.3 och har självklart autostartfunktion.

Start-Stop ner till 6 Volt

Höjdpunkter

96 kHz sampling rate

The HELIX DSP MINI allows to handle all signals with the doubled sampling rate of 96 kHz. Thus the audio bandwidth is no longer limited to usual values like 22 kHz but allows an extended frequency response to more than 40 kHz. Doubling the sampling rate requires significantly higher DSP power as the number of possible arithmetic operations is halved.

Only the implementation of the latest DSP chip generation allows raising the sampling rate to 96 kHz and adding new features at the same time.

Smart highlevel input ADEP.3

Modern, factory-installed car radios incorporate sophisticated possibilities of diagnosing the connected speakers. In particular the latest generation of car radios are equipped with additional monitoring functions so that failure messages and loss of specific features (e.g. fader function) quite often appear if a signal processor will be hooked up - but not with the DSP MINI.

The new ADEP.3 circuit (Advanced Diagnostics Error Protection, 3rd Generation) avoids all these problems without loading the speaker outputs of the OE radio during high volumes unnecessarily.

ACO - Advanced 32 Bit CoProcessor

The HELIX DSP MINI incorporates an extraordinary powerful 32 Bit CoProcessor of the latest generation for all monitoring and communication tasks, both internally and externally. In opposite to the 8 Bit predecessor generation this MCU achieves way higher speeds with respect to setup switching and data communication with our DSP PC-Tool software. A further significant advantage is the integrated, native boot loader of the CoProcessor. It allows software upgrades of all components of the DSP in order to adjust the microcontroller-controlled ADEP.3 circuit for example at future modifications / changes in the diagnostic system of factory radios or if the device will be extended with additional interfaces. In addition, thanks to the new flash memory, the ACO offers 10 memory locations for sound setups instead of the common two.

Start-Stop capability

The switched power supply of the HELIX DSP MINI assures a constant internal supply voltage even if the battery’s voltage drops to 6 Volts during engine crank.

Power Save Mode

The Power Save Mode is incorporated in the basic setup. It allows to significantly reduce the power consumption of the amplifiers that are connected to the HELIX DSP MINI once there’s no input signal present for more than 60 seconds. Please note that in many up-to-date cars with “CAN” or any other internal bus structures it may happen that the radio remains “invisibly” turned on for up to 45 min. even after locking and leaving the car! Once the “Power Save Mode“ is active the remote output and therefore the connected amplifiers will be turned off. The HELIX DSP MINI will reactivate the remote output within a second if a music signal is applied. It is possible to either modify the turn-off time of 60 sec. or completely deactivate the “Power Save Mode” via the DSP PC-Tool software.

Start-Stop capability

The switched power supply of the HELIX DSP MINI assures a constant internal supply voltage even if the battery’s voltage drops to 6 Volts during engine crank.

Automatic Digital Signal Detection

Switching from analog input to the digital input is done automatically as soon as a signal is detected on the Optical Input. This feature can be deactivated in the DSP PC-Tool software. Alternatively you can use an optional remote control for manual switching between analog and digital inputs.

Specifikationer

Inputs

4 x RCA / Cinch

4 x Highlevel speaker input

1 x Optical SPDIF (12 - 96 kHz)

1 x Remote In

Input sensitivity

RCA / Cinch 2 - 4 Volts

Highlevel 5 - 11 Volts

Outputs

6 x RCA / Cinch

1 x Remote Out

Output voltage 4 Volts

Frequency response 10 Hz - 44,000 Hz

DSP resolution 64 Bit

DSP power 295 MHz (1.2 billion MAC operations/second)

Sampling rate 96 kHz

DSP type Audio signal processor

Signal converters A/D: Asahi Kasei

D/A: Asahi Kasei

Signal-to-noise ratio digital input 106 dB (A-weighted)

Signal-to-noise ratio analog input 103 dB (A-weighted)

Total harmonic distortion (THD+N) digital input 0.001 %

Total harmonic distortion (THD+N) analog input 0.002 %

IM distortion (IMD) digital input 0.004 %

IM distortion (IMD) analog input 0.004 %

Crosstalk 90 dB

Operating voltage 9.6 - 18 Volts (max. 5 sec. down to 6 Volts)

Current draw 400 mA

Max. remote output current 500 mA

Additional features HEC slot, Ground lift switch, Control Input, 32 Bit CoProcessor, ADEP.3 circuit, Auto Remote switch

Dimensions (H x W x D) 40 x 177 x 104 mm




Artikelnummer:
HEL-DSP-MINI


Rekommenderade tillbehör till denna produkt
Drift & produktion: Wikinggruppen

Produkten har blivit tillagd i varukorgen